Ball-end, flat-end, corner-end and taper-end cutters are listed separately when clicking on the tabs for choosing type of cutter.This makes it possible to change tool for existing toolpaths when using the recalculate function. New option for gouge checking when using 5-axis profiling.New option for the Between Curves function it is now possible to choose parallel or across curves.(Largest cutters at top) (3X,4X,5X and 5Xtra) The cutters are listed in order of the diameter. New option for postprocessor output from Cplane origin.Gouge checking can be "All curves", "Curve by curve" or "Off". Two new variables for the post processor.This makes it possible to set the zero point for the output by placing a Cplane. Clipping plane error when using flat cutters or corner end cutters.Post processor support for inverse time feed (G93).It is possible to get all cutters that are used and the total machining time listed in the output file. Five axis part trimming with line vectors.This was a problem especially when using flat drive surfaces. The function is changed so the lines has to have the same direction (start point close to curve). File name checker so it prevent users from typing cutter names that can't be saved to file.Especially when having several profile curves with a small distance between. Please be aware that this is an early release of the next service release, so everything is not complete. The help file is not updated and the material removal simulator does not work as well as it will work in the final service release. If you will have trouble with the material removal simulator, just unckeck the "Draw Stock Model" option from the simulator options dialog.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |